To configure the Smart Battery Sensor:

  • go to Home page (Active sensors page)

  • tap on the sensor you wish to configure

  • tap on the gear button located at the top right corner.

Give the sensor a name if you have more than one to know which sensor is sending alerts. Try not to have more than one sensor with the same name.

Here you can check:

  • Sensor ID

  • Subscription start date

  • Subscription expiration date

  • Days until the next billing

Depending on the number of battery banks you wish to monitor, switch on the battery bank #1, and battery bank #2 if necessary, and configure the following parameters:

  • Battery bank name

  • Charging voltage

    • Default value for 12V: 13.5V

    • Default value for 24V: 27V

  • Low battery

    • Default value for 12V: 12.4V

    • Default value for 24V: 24.8V

  • Critical battery

    • Default value for 12V: 10.75V

    • Default value for 24V: 21.5V

  • Type

  • First use

  • Battery name

Change the status of the sensor from Active to Deactive, Delete the sensor or reset the sensor to its default values.

Save the changes you made.

Changes are not instantly applied to the sensor after tapping the Save changes button and until they are, a yellow banner will be visible at the top of your Sensor configuration screen reading Configuration in progress.